Skip to content
Navo24Navo24

Tank Containers.

The 7 tank types you meet in leasing fleets, with capacity, tare, payload and pressures, then the UN T-codes that decide which tank a dangerous liquid may travel in, and how to read the ADR tank code on the plate.

Tank container types

Figures are fleet averages from one lessor sheet; a given tank can differ by a few hundred kilograms. Check the data plate of the unit you get. WP / TP: working and test pressure.

20' standard tank

IMO T11 (ADR L4BN)

The workhorse tank: food grade liquids, non-hazardous chemicals and most hazardous liquids that T11 or a lower T-code allows.

Frame L × W × H6,058 × 2,438 × 2,591 mm
Frame20' ISO full frame
Shell316L stainless, 4.4 to 4.6 mm, 50 mm rock wool insulation, steam heating
CapacityTare, kgPayload, kgMax gross, kgWP / TP, bar
21,000 l5,548 US gal3,46032,54036,0004 / 6
24,000 l6,340 US gal3,62032,38036,0004 / 6
25,000 l6,604 US gal3,75032,25036,0004 / 6
26,000 l6,868 US gal3,80032,20036,0004 / 6
  • Relief valve set at 4.4 bar; bottom outlet with three closures (foot valve, butterfly valve, cap).
Source: Seaco, Tank Containers brochure, April 2025 (PDF), p. 10.

20' baffle tank

IMO T11

Partial loads and dense liquids: baffles break the surge of liquid when the truck brakes or turns, so one tank can carry cargo of different densities.

Frame L × W × H6,058 × 2,438 × 2,591 mm
Frame20' ISO full frame
Shell316L stainless, 4.4 to 4.6 mm, welded or removable baffle plates, 3 cleaning hatches
CapacityTare, kgPayload, kgMax gross, kgWP / TP, bar
26,000 l6,868 US gal4,05031,95036,0004 / 6
  • Baffles cover up to 70% of the barrel section, vertical or horizontal.
Source: Seaco, Tank Containers brochure, April 2025 (PDF), p. 8.

Swap body tank (T11)

IMO T11, ADR/RID L4BN

Bigger volume for road and rail inside Europe and on short sea: the barrel is longer than a 20' frame, so it does not stack in standard ship cells.

Frame L × W × H7,820 × 2,550 × 2,670 mm
FrameBeam frame, 25'8" long, not ISO size
Shell316L stainless, 4.4 to 4.6 mm, 4 welded V-shaped baffles, 12 heating runs
CapacityTare, kgPayload, kgMax gross, kgWP / TP, bar
35,000 l9,246 US gal4,53034,47039,0004 / 6
Source: Seaco, Tank Containers brochure, April 2025 (PDF), p. 14.

20' T20/T22 specialised tank

IMO T20 to T22

Highly toxic, corrosive or reactive liquids (for example titanium tetrachloride): top discharge only, bursting disc ahead of the relief valve.

Frame L × W × H6,058 × 2,438 × 2,591 mm
Frame20' ISO full frame
Shell316L stainless, 6.6 to 6.8 mm, 105 mm insulation, stainless cladding, no bottom outlet
CapacityTare, kgPayload, kgMax gross, kgWP / TP, bar
14,500 l3,830 US gal3,86032,14036,0006.67 / 10
17,500 l4,623 US gal4,80031,20036,0006.67 / 10
21,000 l5,548 US gal4,93031,07036,0006.67 / 10
Source: Seaco, Tank Containers brochure, April 2025 (PDF), p. 16.

20' T50 gas tank

IMO T50

Liquefied gases under pressure: LPG, propane, butane, ammonia, refrigerant gases. Pressure rating is chosen by the gas.

Frame L × W × H6,058 × 2,438 × 2,591 mm
Frame20' ISO full frame
ShellCarbon steel P460NL, 13.4 mm, aluminium sunshield, valves in a locked cabinet
CapacityTare, kgPayload, kgMax gross, kgWP / TP, bar
22.0 bar, 24,600 l6,499 US gal7,10028,90036,00022 / 29.9
27.5 bar, 24,600 l6,499 US gal7,65028,35036,00027.5 / 35.75
34.4 bar, 24,300 l6,419 US gal8,80027,20036,00034.4 / 44.72
Source: Seaco, Tank Containers brochure, April 2025 (PDF), p. 18.

40' T75 cryogenic tank

IMO T75

Refrigerated liquefied gases: LNG (UN1972), ethylene (UN1038), ethane (UN1961). Holding time before venting: about 100 days for LNG, 184 for ethylene, 228 for ethane.

Frame L × W × H12,192 × 2,438 × 2,591 mm
Frame40' ISO frame
Shell304L stainless inner and outer vessel, vacuum multi-layer insulation
CapacityTare, kgPayload, kgMax gross, kgWP / TP, bar
46,000 l12,152 US gal11,80024,20036,00010
  • Inner vessel rated −196 to +20 °C. No test pressure printed on the sheet.
Source: Seaco, Tank Containers brochure, April 2025 (PDF), p. 20.

20' bulk powder (silo) tank

Not a UN portable tank

Dry powders and granules: cement, fly ash, lime, plaster. Discharged by compressed air through a fluidised bed.

Frame L × W × H6,058 × 2,438 × 2,896 mm
Frame20' frame, 9'6" high
ShellCarbon steel 4 mm, epoxy-coated inside, 3 loading hatches, 3 discharge cones
CapacityTare, kgPayload, kgMax gross, kgWP / TP, bar
25.8 m³ (24.5 m³ usable)6,816 US gal3,62030,38034,0001.8
  • Design pressure 2 bar.
Source: Seaco, Tank Containers brochure, April 2025 (PDF), p. 12.

Side by side

The largest variant of each type. On a phone, swipe the table sideways.

TypeCodeMax capacityPayload, kgWorking pressure, barBottom outlet
20' standard tankIMO T11 (ADR L4BN)26,000 l32,2004Yes
20' baffle tankIMO T1126,000 l31,9504Yes
Swap body tank (T11)IMO T11, ADR/RID L4BN35,000 l34,4704Yes
20' T20/T22 specialised tankIMO T20 to T2221,000 l31,0706.67None
20' T50 gas tankIMO T5024,600 l28,90022Yes
40' T75 cryogenic tankIMO T7546,000 l24,20010Yes
20' bulk powder (silo) tankNot a UN portable tank25,800 l30,3801.8Pneumatic

UN portable tank instructions T1 to T22

Column 10 of the Dangerous Goods List names the minimum instruction for each UN number. A tank built to a stricter instruction can carry the cargo too. "Standard" shell: the thickness from the general formula (ADR/IMDG 6.7.2.4.2), at least 5 mm reference steel for tanks over 1.80 m diameter.

T-codeMin test pressure, barMin shell, ref. steelPressure reliefBottom outlet
T11.5StandardSpring relief valve2 closures
T21.5StandardSpring relief valve3 closures
T32.65StandardSpring relief valve2 closures
T42.65StandardSpring relief valve3 closures
T52.65StandardBursting disc before the valveNot allowed
T64StandardSpring relief valve2 closures
T74StandardSpring relief valve3 closures
T84StandardSpring relief valveNot allowed
T946 mmSpring relief valveNot allowed
T1046 mmBursting disc before the valveNot allowed
T116StandardSpring relief valve3 closures
T126StandardBursting disc before the valve3 closures
T1366 mmSpring relief valveNot allowed
T1466 mmBursting disc before the valveNot allowed
T1510StandardSpring relief valve3 closures
T1610StandardBursting disc before the valve3 closures
T17106 mmSpring relief valve3 closures
T18106 mmBursting disc before the valve3 closures
T19106 mmBursting disc before the valveNot allowed
T20108 mmBursting disc before the valveNot allowed
T211010 mmSpring relief valveNot allowed
T221010 mmBursting disc before the valveNot allowed
  • T23: self-reactive substances (class 4.1) and organic peroxides (5.2), set per substance with control and emergency temperatures.
  • T50: non-refrigerated liquefied gases (LPG, ammonia, refrigerants), pressure and filling ratio set per gas.
  • T75: refrigerated liquefied gases (LNG, liquid nitrogen, ethylene).
  • Which class each UN number belongs to: IMO Classes.

Source: portable tank instructions, ADR and IMDG Code 4.2.5.2.6 (same table in both); IMO, Dangerous goods.

Reading the ADR tank code: L4BN

Road (ADR) and rail (RID) use a four-part code instead of the T-code. Most T11 tanks also carry L4BN on the plate.

L

Cargo state

L = liquids. S = solids (powders, granules), G = compressed or liquefied gases, C/P/R = other gas tank types.

4

Calculation pressure

Minimum calculation pressure in bar: 1.5, 2.65, 4, 10, 15 or 21. G means the general requirements apply instead of a number.

B

Openings

A = bottom filling or discharge with 2 closures, B = with 3 closures, C = top only except cleaning holes, D = top only, no opening below the liquid.

N

Safety valves

V = vacuum valve, F = flame-arrested vent, N = no hermetic closure needed (relief valve allowed), H = hermetically closed tank.

Source: ADR 4.3.4.1.1 (tank codes for tanks other than gas tanks).

Questions

What is a T11 tank container?

A 20-foot ISO tank built to UN portable tank instruction T11: minimum test pressure 6 bar, bottom outlet with three closures allowed. Typical capacity 21,000 to 26,000 litres, max gross 36,000 kg.

How much does an ISO tank container hold?

A standard 20-foot tank holds 21,000 to 26,000 litres. Swap body tanks reach 35,000 litres, 40-foot cryogenic tanks about 46,000 litres, specialised T20/T22 tanks 14,500 to 21,000 litres.

Can a tank with a higher T-code carry cargo assigned a lower one?

Yes. The Dangerous Goods List gives the minimum instruction. A tank meeting a stricter instruction (higher test pressure, thicker shell, fewer bottom openings) may be used, as set out in ADR/IMDG 4.2.5.2.5.

Why do tank containers have baffles?

Baffle plates break the surge of a part-filled liquid load when the vehicle brakes or turns. Without baffles a tank must normally be filled to at least 80% or less than 20% of its capacity.

Every box type with inside dimensions: Container Types. Who owns a leased tank: Container Lessors.

Track a container

Container, B/L or booking number. 240+ carriers, live status and ETA.